Tired of cuts from wire ties that have been trimmed with standard wire cutters?
• Allstar Wire Tie Tool • This tool does a great job of drawing ties tight around bundles of wires or cables in tight areas. • Easily cuts flush with a twist of the wrist. • ABS constructed tool has steel cutting blades and works with common size wire ties.
• Contain the mess of bleeding brakes. • Capture fluid in this 16 oz. bottle with a 12" long hose which attaches to most bleeder screws. • Removable cap has a built-in fitting to secure the hose during storage to help prevent spills. • Choose from a steel lanyard retainer that suspends the bottle from a chassis or suspension component or a magnet retainer to secure the bottle to a steel object such as a brake drum or rotor during bleeding.
• Drill multiple size holes with one bit. • Drill sheet metal and aluminum without deforming or distorting. • Bits start on contact, deburr and chamfer while drilling and do not require a center punch. • Titanium nitride coated high speed steel. • 1/4" shank.
• Titanium coated tungsten steel taps • Right-hand and Left-Hand threads • Available in a large selection of sizes
• Add strength and a smooth finish to hole edges. • Unique tools can be used to punch and flare new holes, or to flare existing holes. • Starting with a small center hole, the punch halves bolt together to cut and flare at the same time.
• Five piece, aluminum wrench set for use with aluminum AN-style, braided hose fittings. • AN Sizes included are -6, -8, -10, -12, and -16. • Each wrench is finished in different color anodizing for easy identification.
• Eliminate the guesswork of which wrench is needed to tighten, remove or check steel braided hose fittings. • 8" Aluminum wrench prevents damage to fittings. • Adjustable wrench sizes available in 0-10 AN or 0-20 AN.
• Ball Joint Spreader Tool • Tool separates ball joint from the spindle. • Inside of cylinder is shaped to fit over tapered stud of most ball joints and presses against stud of other ball joint. • Not for use on FWD or 4WD applications. • Tool is 4" tall fully collapsed and 6" tall fully extended.
• GM Metric Spindle Checker Tool Kit with 2" Taper. • Assure correct alignment of the upper and lower ball joint when checking for bent spindles. • Insert slugs into spindle and guide rod will fit through slugs if spindle isn't bent. • Kits fit most aftermarket race and GM stock metric spindles.
• Pencil works well for marking lines during metal layout and fabrication • Multiple uses include marking steel tubing for cutting or notching and marking patterns on painted aluminum or steel sheet metal • Silver reflective marks work best against darker surfaces during cutting or welding for high visibility • Pencil marks are resistant to torch flames and will not burn or rub off • Sold as 3/Pack