Tools, Dollies & Set Up Blocks

• Strong, sturdy construction won't buckle under high load capacity
• Black Powdercoat for a great looking finish
• Adjustable Height from 13" to 19"
• Collapsable to lay flat for easy storage in shop or hauler
• Heavy duty casters make moving your race car around the shop easy
• A brake on each stand to prevent rolling when working on car
• Light weight
• Removable 1" block on left side so stand fits both raised rail and standard rail chassis
• Sold as a pair

• 3-6" adjustable setup blocks
• Adjustable in 1/4" increments
• Magnetic

Timing or leveling your Birdcages is one of the most important parts of any chassis set-up. This new tool will make doing the job a snap! It’s CNC machined from ABS plastic and neatly snaps around your upper rear radius rod bolt sleeve and slips down around the rear axle O.D., then just center the bubble in the Level
and you’re done. Fits Maxim, Eagle, and any other style where the bolt runs parallel to the Axle. This is a great tool and will eliminate any guess work.

Safety is #1 and getting your driver tight and secure ensures that he is safe and can gas it up. It has always been hard to get the Seat Belt tight until now.
This handy tool lets you slide one end through the Seat Belt Loop and pull.
FEATURES:
• Made from Steel Alloy
• Heli-Arc Welded
• Powder Coated Finish
• Works On All Seat Belts

These radius rod building gauge bars are a simple tool for setting the length of tie rods and radius rods on your street rod, modified, or sprint car racing chassis. Perfect for the at-home custom builder, they also work great for determining length needed for drag links, four-link systems, and other linkage rods. Simply match the gauge bar ends up with your heim joint or rod ends and use the adjusting knob to slide the end to your desired placement. Mark the new length and you're ready to create your own custom length radius rods!

• Designed for use with 1/2", 5/8" and 3/4" rod ends, and with an overall rod length of 32"
• Perfect for setting custom tie rod, radius rod, drag link, and four-link tube lengths
• Make quick, easy and precise adjustments with one simple tool

We have all rolled our Drive Shaft or Torque Tube on the ground trying to see if it was bent and couldn't tell. Well here is the answer, with Precision Ground Bearings and a Sturdy Aluminum Base this Checker will eliminate any questions whether your Drive Shaft, Radius Rod, Torsion Bar, or Torque Tube is bent. A must have item for every Sprint or Midget Team.
Features:
• All Aluminum Construction
• Anodized Black Finish
• User Friendly

• Frame Stand and Dolly complete with all pins, castors and high density rubber pads to keep lower frame rails from scratching
• Adjustable Height - adjustments from 13" to 19"
• Strong, sturdy construction from lightweight, plated steel
• Collapsable to lay flat for easy storage in shop or hauler
• Rounded casters for ease of rolling
• A brake on each stand to prevent rolling when working on car
• Removable 1" block on left side so stand fits both raised rail & standard rail chassis

• 1-3/4" thru 4" adjustable setup blocks
• Adjustable in 1/4" increments
• Magnetic

• 7-piece AN wrench set
• Aluminum construction
• Size stamped on wrech for easy identification
• Sizes 03, 04, 06, 08, 10, 12 & 16