Brake Accessories

• Brake line retaining clips designed to keep your brake lines mounted solidly in place
• Clips into place for a secure attachment
• Strong steel construction
• Sold in 4/Pack

• Steel bearing brake floater
• Can be mounted on right or left side
• Each floater comes with 2 retainers, 1 birdcage spacer & 1 bearing spacer

• Kit includes bearing (10344), hub seal (10383), washer (10205) & right-hand locknut (10207)
• Axle seal 10384 sold separately (not in kit)

• Kits (Part 10350 & 10352) fit all 3/4 ton Wide 5 hubs except early Howe
• Kit (10350) includes includes bearings, seal, washer & standard locknuts (10150)
• Kit (10352) includes bearings, seal, washer & self-locking nuts (10200)

• Manual Brake Shutoff Valve With 3/16" Inverted Flare Line Fitting
• Used to block pressure from reaching downstream
• Does not prevent fluid from returning to master cylinder
• Compact design, easy to install
• For racing purposes only, not line locks & not for street use

• Magnet holds bottle while you bleed your brakes
• No more spilled fluid
• Hoses connect to bleeder valves - bleed one at a time or both at once
• Cap for hoses prevents leakage during storage
• Comes with 1/4" bleed wrench

Versa-Shield was designed to protect starters from potential failure caused by under hood heat soak conditions. Constructed using an aluminized heat reflective material backed with a hi-temp rated glass fiber insulation barrier, Versa-Shield is capable of reflecting radiant heat up to 2000°F.

• Withstands 500°F of direct heat/2000° radiant
• Edges attach to itself with hook & loop closure design
• Universal-trim length to size
• Can easily be removed for shows
• No need to remove starter for installation in most cases
• Multiple uses to protect master cylinders, cool cans, distributors, fuel pumps & more
• 7” wide x 24” long

Designed to slide over wires, cables and hoses, Heat Sheath provides the ultimate protection from extreme heat as well as chemical and oil spills, dirt, grease and road grime. Constructed from a high temperature fabric and bonded to an aluminized material to reflect heat. Heat Sheath is fireproof and withstands direct heat up to 500°F.

• Pliable for tight bends
• Capable of withstanding 500°F direct / 2000°F radiant heat
• Five popular diameters to choose from
• Trim to desired length

Heat Shroud is made from a high temperature rated glass fiber fabric with an aluminized outer facing. Same as Heat Sheath but with the added convenience of hook & loop closure design along the open edges. Without the need of removing one end of connected wires, cables and hoses, simply wrap Heat Shroud around whatever needs protection and close edges.

• Versatility of fitting diameters 1/2" to 1-1/4"
• Convenient hook & loop designed edges
• Withstands 500°F direct continuous/2000°F radiant heat
• No need to remove wires and hoses
• Easily trimmed to length
• Fireproof
• 1/2” to 1-1/4” diameters x 3 foot length