Suspension Accessories

• GM lower spindle checker tool kit, 2" taper
• Assures correct alignment of the upper and lower ball joint when checking for bent spindles
• Insert slugs into spindle and guide rod will fit through slugs if spindle isn't bent
• Kits fit most aftermarket race and GM stock metric spindles

• Chrysler lower spindle checker tool kit, 1-1/2" taper
• Assures correct alignment of the upper and lower ball joint when checking for bent spindles
• Insert slugs into spindle and guide rod will fit through slugs if spindle isn't bent
• Kits fit most aftermarket race and GM stock metric spindles

• Adjustable ball joint holder for control arms
• Use with K772 "wide style" standard upper screw-in ball joint and 5/8" tubes
• Fits most adjustable tubular upper control arms
• 5/8" Right hand Male thread

Machined from 4140 US Military spec chromoly bar. After being machined and atomically broached, they are heat treated for optimum strength and black oxide coated so they won’t rust.

• Chromoly torsion stop
• 1 3/4" torsion bar split
• Comes complete with all grade 8 hardware
• Available in Black

• 25 Lb Clamp-On Weight Ballast, 4" x 5".
• Securely add weight where it's needed.
• Clamp-on design is formed of two halves which bolt together around 1" to 1-3/4" round tubing allowing easy installation and removal.
• Bolts are included for use on tubing up to 1-5/8".
• When clamping to 1-3/4" tubing, longer bolts (not included) are required.

• Allstar 2" x 2" Square Tube Ballast Bracket.
• Ballast brackets are used for mounting ballast or components that need to be moved or adjusted easily.
• Black anodized two piece aluminum bracket clamps around tubing with recessed 5/16" socket head fasteners.
• Has a 1/2"-13 tapped hole on each side for a ballast mounting stud (sold separately).

• Allstar Round Tube Ballast Brackets.
• Ballast brackets are used for mounting ballast or components that need to be moved or adjusted easily.
• Black anodized two piece aluminum bracket clamps around tubing with recessed 5/16" socket head fasteners.
• Has a 1/2"-13 tapped hole on each side for a ballast mounting stud (sold separately).

• QA1 Rear trailing arm hardware kit
• Fits 1964-72 GM A-Body
• These kits replace factory hardware with new bolts, A/N washers and nylock nuts

This Moog brand replacement Idler Arm is just what you need to ensure the safety and integrity of your vehicle's suspension and steering.

• Bolts to RH (Passenger Side) Frame
• Replaces dealer part numbers: 26041013
• Attaches to relay rod or drag link
• Direct replacement
• Built to strict quality control standards
• Fits 2WD models with power steering