Chassis Tools

• Specially hardened drill bit is required for drilling spring steel
• 17/64" size simplifies installation of 1/4" hardware
• Sold each

• Set-up plates are used for squaring and stringing chassis to ensure accurate chassis set-up by eliminating wheel and tire differences.
• Plates are 1/2" thick and can also be used when setting bump steer or checking axle tubes for straightness.
• Sold each.
• Set Up Plate 5x5, 7" x 28"

Not sure if you turned your wheels the same amount each time when adjusting caster settings on your race car? Unless you have expensive turn plates, you’re never certain, until now.

• Wheel Caster Setting Plate
• This quick reference gauge positions under the upper ball joint nut, with markings facing up, to easily view.
• Place a mark on the shock body or fabricate an indicator to use as a reference point.

• Titanium coated tungsten steel taps
• Right-hand and Left-Hand threads
• Available in a large selection of sizes

• Add strength and a smooth finish to hole edges.
• Unique tools can be used to punch and flare new holes, or to flare existing holes.
• Starting with a small center hole, the punch halves bolt together to cut and flare at the same time.

• Five piece, aluminum wrench set for use with aluminum AN-style, braided hose fittings.
• AN Sizes included are -6, -8, -10, -12, and -16.
• Each wrench is finished in different color anodizing for easy identification.

• Ball Joint Spreader Tool
• Tool separates ball joint from the spindle.
• Inside of cylinder is shaped to fit over tapered stud of most ball joints and presses against stud of other ball joint.
• Not for use on FWD or 4WD applications.
• Tool is 4" tall fully collapsed and 6" tall fully extended.

• GM Metric Spindle Checker Tool Kit with 2" Taper.
• Assure correct alignment of the upper and lower ball joint when checking for bent spindles.
• Insert slugs into spindle and guide rod will fit through slugs if spindle isn't bent.
• Kits fit most aftermarket race and GM stock metric spindles.

• Pencil works well for marking lines during metal layout and fabrication
• Multiple uses include marking steel tubing for cutting or notching and marking patterns on painted aluminum or steel sheet metal
• Silver reflective marks work best against darker surfaces during cutting or welding for high visibility
• Pencil marks are resistant to torch flames and will not burn or rub off
• Sold as 3/Pack