Shopping

• Chevy Motor Mount Pads
• Zinc Finish
• Use with Moroso Motor Mounts No. 62510
• Fits: 1982-'92 Camero and Firebird, SBC, BBC, and 90° Chevy V6
• Solid Motor Mounts must be used in conjunction with Solid Transmission Mounts to prevent breakage of engine block and transmission case due to torsional stress
• Solid Mount Pads replace soft rubber-cushioned frame mounts supplied as OEM equipment on 1974-'97 Camaro and Firebirds and other GM vehicles
• Control excessive engine movement, prevent linkage binding and eliminate the need for torque straps
• 2 per pack

• Chevy V8 & 90° V6 Filler Neck Manifold Housing
• Locates filler neck at highest point on cars with low-mount radiators to bleed off air
• Unit can be flipped 180° for either right or left outlet location
• Includes 1/2" NPT fitting for installing water temp sending unit & two 1/4" NPT fittings for return lines on popular aftermarket cylinder heads
• Made of 356-T6 cast aluminum - 3-1/4"
• Includes gaskets, bolts, and washers, and standards size radiator cap filler neck

• Black Billet Aluminum Filler Neck
• Fits Small Block, Big Block, and 90° V6 Chevy Intake Manifolds
• Features -16 AN fitting and two 3/8" NPT female ports to plumb water to cylinder head for cooling
• Includes gasket

• Billet Aluminum Filler Neck, Weld-On
• Made from 6061-T6 billet aluminum
• This weld-on version can be used wherever a heavy-duty, custom-application filler neck is required
• Includes screw-in 1/8" NPT hose fitting for expansion tanks, and accepts Moroso or standard-size radiator cap (not included)

• Water pump spacer kit
• Small Block & 90° V6 Chevy
• Converts "short" 1968-earlier design Chevrolet water pumps to longer, 1969-later design
• Includes special heat-treated bolts & gaskets
• Fits Moroso 63500 & 63505 water pumps

• Temperature Gauge Fitting
• Corrosion resistant brass
• Fits standard 1/2" NPT tapped holes in cylinder heads and manifolds
• 5/8" -18 threaded hole in fitting accepts popular sending units

• Radiator Recovery Tank
• Lightweight Aluminum design holds one full quart capacity
• Can be used in many forms of competition: NHRA, IHRA and SCCA accepted
• Vented recirculating tank includes push-lock fitting (for 1/4" O.D. flexible tubing), barbed fitting (for 3/8" rubber hose), siphon tube and drain fitting
• Dimensions: 9" high (overall), 3-1/8" tank diameter

• Carburetor Linkage Bushing Kit
• Steel linkage bushing set allows the fitting of a 1/4" fastener to the 1/2" diameter hole found in the throttle linkage plate of Holley® 4 barrel carbs
• Split bushing design permits simple installation and eliminates the sloppiness present when rubber bushings are used
• Clear zinc finish

• Float Bowl Washer Kit For Holley® Carbs
• The ultimate cure for the problem of soft, wet, deteriorating fiber, Holley® float bowl washers
• Our nearly indestructible nylon replacement washers are unaffected by fuel, and won't leak or break down under normal usage
• Ten per package