Shopping

• Small Block Chevy Spiral Core Sleeved Wire Sets
• 8 mm 800 ohm Spiral Core Wire pre-terminated at both ends
• Complete, pre-assembled ready to install sets with 36" coil wire
• Each wire is tested for continuity and resistance after termination to ensure race-ready performance
• High-temp silicone 90° Black spark plug boots provide maximum heat protection
• Shrink tubing at each ends completes the wire-to-boot sealing
• Numbered ID tags simplify installation
• Application Options: Over Valve Cover or Under Header
• Distributor Cap Style: HEI or Non-HEI
• Insulating sleeve runs the entire wire length, adding 8,000 volts of additional insulation
• Available in Black, Red or Blue with Smiley's logo on connector

• For use with Moroso Stud Girdles
• Fits 7/16" Rocker Studs
• Hex head design allows easier valve adjustments with a set screw providing a positive lock
• Fits either stock or roller rockers
• Four per pack

• Oil Pump Shaft - BB Chevy Stock Height
• 6.50" Length
• Blade Pump Drive
• High-quality steel for extended reliability
• Steel sleeve is pinned to maintain correct alignment between oil pump & shaft
• Use on pumps 22144, 22150, 22160, 22163, 22175, 22185

• Oil Pump Shaft - Small Block Chevy using Big Block Chevy Pump
• 5.625" Length
• Blade Pump Drive
• High-quality steel for extended reliability
• Steel sleeve is pinned to maintain correct alignment between oil pump & shaft
• Use on Pump Nos. 22144, 22150, 22160, 22163, 22175, 22185

• Positive Seal Vented Air Inlet Fitting, -12AN
• Designed to simplify the plumbing of a vacuum pump
• Screws into side of valve cover
• Provides leak-free O-ring seal on flat valve cover surfaces
• No welding required

• Allows fastening through valve covers
• Vacuum relief point adjustable by shimming an internal spring to get precise amount of vacuum desired
• Can be disassembled for easy cleaning & maintenance
• Will work with any vacuum level
• 6061 aluminum with smooth, attractive finish

• External Heating Pad, 6" x 12", hook and spring attachment
• 360 Watts
• 8" 110V cord
• Excellent for pre-heating of oil pans, tanks and automatic transmission pans
• Installs with hook and spring attachment
• Etched foil design distributes heat evenly
• Silicone outer shell resists oil and dirt

• Increases horsepower by shielding bottom of intake manifold from hot oil
• Keeps surplus oil out of valve covers by eliminating oil splash
• Maintains oil pressure during pushrod or rocker arm failure by keeping lifters in their bores (except with roller cam)
• Due to slight variation in blocks, the baffle may have to be trimmed .060-.100" before it will "snap" into place
• Cannot be used with roller lifters

• Reduces crankcase pressure throughout entire rpm range for increased piston ring seal, reduced intake charge contamination, and fewer oil leaks
• Track and dyno tests prove increases in engine performance
• Includes 2 each: Oil Separators/Breathers, Breather/Filler Cap Grommets, One-Way Check Valve and Weld-In Nipple for header collector, use with 5/8" dia. hose (not included)
• Not recommended for use on vehicles with mufflers or downstream wideband/oxygen sensors