Shopping

Complete Bearing and Installation Kit for 9” Ford
Includes:
• Carrier Bearings
• Pinion Bearings
• Pilot Bearing
• Crush Sleeve
• Nuts
• Pinion Seal
• Ring gear bolts and gasket
• 1.781 ID
• 2.89” OD

• Complete Ford 9" gear sets are ready to bolt-in
• Manufactured with Performance Engineering gear sets
• Available in 28 Spline or 31 Spline
• Large selection of ratios ranging from 3.50 to 4.71
• Choose standard or lightweight
• Includes carrier, gears and full spool

• Complete Ford 9" gear sets are ready to bolt-in
• Manufactured with Performance Engineering gear sets
• Available in 28 Spline or 31 Spline
• Large selection of ratios ranging from 3.50 to 6.50
• Includes carrier, gears and mini-spool

• Ford 9" solid pinion spacer kit
• Includes shims
• Allows you to change your yoke without altering bearing preload

• PEM GM 7.5" 10-Bolt Mini Spool
• 26-spline
• Used for car rear ends

• PEM 9" Ford Mini Spool
• 28-Spline

• 650 Series Lightweight Premium Quick Change Gear Sets by PEM
• High Strength Alloy Steel for higher horsepower cars with bigger tires
• Lightweight drilled
• 1.5 lbs. lighter decreases your rotating weight
• Lightening will vary on different gear sets
• REM ISF® micro polished for less friction and longer life - QC Gears run cooler with REM finishing!
• 10 spline gears - Fits Winters, Frankland, Bulldog (DMI), Tiger, Halibrand, Jones, PEM and other Quick Change Rear Ends
• Check the gear chart below for ratios available

• 7.5" GM Flanged 26-Spline Axle with REM Finish
• Stock OEM replacement
• Bolt Patterns: 5 x 4.75" or 5 x 5"
• Bolt patterns drilled for 5/8" studs
• Length: 28"
• Note: Does not fit Camaro or Firebird
• Sold individually

• PEM Quick Change Bolt-On Upper GM Metric Mount Kit for Housing
• Fits Quick Change Rear Ends, PEM, Winters, DMI, Tiger and Frankland Rears.
• 4 degrees down pinion angle built in with stock length radius rods
• Poly top bushings for stock style General Motors radius rods
• Raw Mild Steel, Not painted