Shopping

• 5 ft harness shipped ready-to-install
• Harness consists of 4 individually labeled wires
• A1 & B2 connect to starter solenoid
• C3 connects to coil, MSD system or HEI distributor
• D4 connects to cockpit accessories

• 5 ft HEI wiring harness shipped ready-to-install
• Harness consists of 4 individually labeled wires
• A1 & B2 connect to starter solenoid
• C3 connects to coil, MSD system or HEI distributor
• D4 connects to cockpit accessories

• Standard Single Pole Type
• Designed for use with 12 Volt systems
• Designed to Fit 1/2" I.D
• Mounting Hole
• Sold each

• On/Off double pole with bridges connecting the (2) top poles together and (2) bottom poles together
• Works well for 12 volt electrical systems
• Designed to Fit 1/2" I.D
• Mounting Hole
• Sold each

• Standard switch used to engage a starter solenoid
• The same Push Button comes pre-wired into many of QuickCar's Switch Panels, and fits a 5/8" I.D
• Mounting hole
• Works well with 12V and 16V systems
• Sold individually.

• Designed for #6 ring terminals
• Fits in 1/2" I.D
• Mounting hole
• Rated for 25 amps at 12V

• Green pilot light replacement
• For QuickCar ignition switch panels

• Master disconnect switch
• Most sanctioning bodies require these for emergency cutoff switch
• Red epoxy-coated handle & mounting plate
• Panel 2-1/2"W x 2-1/2"H

• Master disconnect switch with alternator posts
• Most sanctioning bodies require these for emergency cutoff switch
• Red epoxy-coated handle & mounting plate
• Panel 2-1/2"W x 2-1/2"H