Shopping

• Rubber offset gauge grommet isolates the gauge from engine vibrations
• Provides tight, lightweight solution to holding gauge in place
• Grommet moves gauge 3/4" towards the driver to give more room behind the gauge
• Designed for 2-5/8" gauges, mounting panel will need a 2-3/4" hole for correct tolerances
• Great for Sprint car drivers

Lightweight aluminum panels have digital, 2-1/16" diameter electronic oil pressure and water temperature gauges with bright blue readout and graduated scale for increased readability. Built in warning lights, which are adjustable, cause the gauge to flash in the event of a problem. This Panel does not have a battery, so the vehicle must have a 12 volt power source. Kit includes all wiring, and senders.

• Digital Open Wheel 2-Gauge Panel
• 67-003 Oil Pressure Gauge, 0-100 psi
• 67-006 Water Temperature Gauge, 100-280 °F
• 63-220 Water Temperature Sender (one wire)
• 63-225 Water Temperature Sender (2 wire)
• 63-230 Oil Pressure Sender
• Weight: 1.50 Lbs

Lightweight aluminum panels have digital, 2-1/16" diameter electronic oil pressure and water temperature gauges with bright blue readout and graduated scale for increased readability. Built in warning lights, which are adjustable, cause the gauge to flash in the event of a problem. Weather resistant panels use a 12-volt rechargeable battery for power. Kit includes all wiring, senders, battery, and charger.

• Digital Open Wheel 2-Gauge Panel with Battery Pack and Charger
• 67-003 Oil Pressure Gauge, 0-100 psi
• 67-006 Water Temperature Gauge, 100-280 °F
• 63-220 Water Temperature Sender (one wire)
• 63-225 Water Temperature Sender (2 wire)
• 63-230 Oil Pressure Sender
• 63-604 Replacement Battery Charger
• 63-605 Replacement Battery Pack
• Weight: 2.00 Lbs

• No mounting Panel
• Designed to be mounted by user in the location of their choice
• Includes hardware to be installed in a 3/4" hole
• Most racing organizations and sanctioning bodies require these for an emergency cut-off switch
• QuickCar's master disconnect switches have a bright red epoxy coated handle
• Accept 3/8" ring terminals

• QuickCar Switch Panel comes with 1 ignition switch and 1 starter button installed in a black plate
• Double pole ignition switch is covered with a protective black boot
• Panel dimensions are 3-3/8" wide and 3-5/8" tall
• Panel comes assembled and pre-wired with mounting holes already punched out to make installation simple
• All wires are professionally crimped, soldered, and heat shrunk for superior quality
• 50-802 is a direct fit to QuickCar's 50-200 and 50-201 wiring harnesses
• Harness and installation hardware not included

• QuickCar Switch Panel comes with 1 ignition switch and 1 starter button installed in a black plate
• The double pole ignition switch is covered with a red flip cover
• Panel dimensions are 3-3/8" wide and 3-5/8" tall
• Panel comes assembled and pre-wired with mounting holes already punched out to make installation simple
• All wires are professionally crimped, soldered, and heat shrunk for superior quality
• 50-803 is a direct fit to QuickCar's 50-200 and 50-201 wiring harnesses
• Harness and installation hardware not included

• QuickCar Switch Panel comes with 1 ignition switch, 1 starter button, and 1 accessory switch installed in a black plate
• Double pole toggle switches come with black protective boots
• Panel dimensions are 4-5/8" wide and 4-3/8" tall
• Panel comes assembled and pre-wired with mounting holes already punched out to make installation simple
• Switches come with colored indicator lights to signal if the switch is turned on or off
• All wires are professionally crimped, soldered, and heat shrunk for superior quality
• 50-822 is a direct fit to QuickCar's 50-200 (ignition box) or 50-201 (HEI) wiring harnesses
• Harness and installation hardware not included

• QuickCar Switch Panel comes with 1 ignition switch, 1 starter button, and 1 accessory switch installed in a black plate
• Double pole toggle switch ignition has a flip cover while the accessory has a black boot
• Panel dimensions are 4-5/8" wide and 4-3/8" tall
• Panel comes assembled and pre-wired with mounting holes already punched out to make installation simple
• Switches come with colored indicator lights to signal if the switch is turned on or off
• All wires are professionally crimped, soldered, and heat shrunk for superior quality
• 50-823 is a direct fit to QuickCar's 50-200 (ignition box) or 50-201 (HEI) wiring harnesses
• Harness and installation hardware not included