Shopping

• 1/2'' set
• Unique heim center finders are designed to allow the racer to set up spare arms once the car is set up
• This is done simply by removing the arm, bolting the tape measure center finder into one end and placing the center pointer on the other and measuring.
• When you establish a measurement place the finder set into the spare and adjust to match the length of the heim.
• When the tape end is bolted in, snug it, hook it, and pull it to let the finder square itself. then just tighten, and you are ready to go.
• Product is designed to take the work out of eyeing up bolts in a critical situation when an identical spare is crucial.
• Finder sets are available for 1/2'', 5/8'', and 3/4''. 1/2'' set.

• Lightweight accessory clamp for 1-1/2" tube
• 1/4"-20 hole on top and side of clamp

• 1-1/2" Accessory clamp
• 1/4"-20 tapped hole on both sides

• Clamp on mounts for 1/2"-20 hood pins
• 9-1/2" tall mount for 1-1/4" tube
• Height is measured from center of tube to top of mount

• Lightweight accessory clamp for 1-1/2" tube
• 1/4"-20 hole on top and side of clamp

• Clamp on mounts for 1/2"-20 hood pins
• Hinged style mount for angled hoods/bay bars so the pin can get square with the body
• 4-1/2" tall mount for 1-1/2" tube
• Height is measured from BOTTOM of tube to top of mount

• Clamp on mounts for 1/2"-20 hood pins
• Hinged style mount for angled hoods/bay bars so the pin can get square with the body
• 6-1/2" tall mount for 1-1/4" tube
• Height is measured from BOTTOM of tube to top of mount

• Clamp on mounts for 1/2"-20 hood pins
• Hinged style mount for angled hoods/bay bars so the pin can get square with the body
• 4-1/2" tall mount for 1-1/4" tube
• Height is measured from BOTTOM of tube to top of mount

• Clamp on screw jack mount for 1'' coarse screw jacks
• 1-1/4" Style
• Allows you to mount a screw jack without welding to your frame
• Places jack bolt 2'' off center of tube
• Mounts are available for 1-1/4", 1-1/2'', and 1-3/4'' tubes
• Screw jack sold separately