Shopping

• Ball Joint Spreader Tool
• Tool separates ball joint from the spindle.
• Inside of cylinder is shaped to fit over tapered stud of most ball joints and presses against stud of other ball joint.
• Not for use on FWD or 4WD applications.
• Tool is 4" tall fully collapsed and 6" tall fully extended.

• Aluminum, standard spun carburetor hat
• Hat covers open carbs and prevents debris from falling into the engine while the air cleaner is removed
• 2-1/2" tall carb hats are designed to fit most carbs or throttle bodies with a 5-1/8" diameter neck
• Hats will not clear choke linkage or shaft on Holley style carbs but will clear choke horn with choke linkage and shaft removed

• Inside Air Blower Motor.
• Inside air unit is commonly mounted inside the cockpit or decking to provide forced, filtered air to the driver for cooling and to help prevent shield fogging.
• Spun aluminum cover prevents damage to filter assembly.
• Motor has two speeds and is recommended for 12 volt systems.

• Front lower control arm 1978-88 metric, righthand
• Reproduction of the originals, these new arms are a direct replacement for 1978-88 metric chassis
• Accept stock ball joints

Tired of cuts from wire ties that have been trimmed with standard wire cutters?

• Allstar Wire Tie Tool
• This tool does a great job of drawing ties tight around bundles of wires or cables in tight areas.
• Easily cuts flush with a twist of the wrist.
• ABS constructed tool has steel cutting blades and works with common size wire ties.

• Small Block Chevy valve covers with tubes
• Tig welded covers are lightweight with a thick rail for gasket support
• 1-3/8" breathers sold separately

• Hard-to-find O2 sensor fittings work in a variety of uses
• Steel oxygen sensor weld-in bung
• Angled style
• 18mm x 1.5

• Steel 1" -8 righthand jack bolt nut
• Standard hex jam nut
• Great for locking rod ends tightly on suspension tubes or rack and pinion • Sold each

• Plastic Plug Kit
• A must for keeping debris out of lines and hoses.
• Ideal for keeping internal components of dry sump pumps, fuel pumps, pressure regulators, etc. clean during storage.
• Caps and plugs fit 37° flared fittings and straight threaded ports.
• Kit includes 5 of each size -03 to -16 AN.