Shopping

• Tie downs are great for securing vehicles and pit equipment during transport.
• 2" x 8' long straps have heavy duty plated hardware,
• Ratchet designed to hold excess strap material as it is pulled through and wrapped up during tightening.
• The working load limit is the maximum load a strap should be subjected to during normal use.

• Hammer type spring steel punch
• Spring steel punch places a 1/4" diameter hole 1/2" from the end of Allstar's 1" x .062" thick spring steel material
• Built-in stop positions material for accurate hole placement
• Place on a hard surface and strike with a 3 to 4lb hammer

• Steering Shaft Rod End Kit
• Mounts to steering column bracket to hold steering shaft in place.
• Kit includes one rod end and two steel 3/4" RH jam nuts.
• Rod end is .757" I.D. (.007" oversized) to slide over a 3/4" O.D. shaft.

• Axle straps or winch straps work great for wrapping around the chassis or axle tubes when securing a vehicle to the trailer or when winching a vehicle.
• Adjustable protective sleeve can be positioned as needed to help prevent strap damage from sharp edges.
• The working load limit is the maximum load a strap should be subjected to during normal use.
• Axle Strap With Twist Hooks, Adjustable 24"-40"

• GM Metric Spindle Checker Tool Kit with 2" Taper.
• Assure correct alignment of the upper and lower ball joint when checking for bent spindles.
• Insert slugs into spindle and guide rod will fit through slugs if spindle isn't bent.
• Kits fit most aftermarket race and GM stock metric spindles.

• Allstar Rivet Gun Adapter for Cordless Drill.
• Adapter is for reversible cordless drills.
• Greatly speeds up the installation of "blind" rivets commonly used when building race car bodies. T
• Tool is a real hand and time saver compared to hand operated rivet guns.
• Designed for use with all rivets up to 3/16" including 3/16" aluminum mandrel rivets (not recommended for 3/16" steel mandrels).
•Adapter includes nosepieces for installing 3/32", 1/8", 5/32" and 3/16" rivets.

• Driveshaft Loop 180 Degree 1" x .083" Round Tubing
• Pre-bent 1" diameter x .083" wall mild steel tubing is designed for chassis style cars to help retain the driveshaft in the event of a u-joint failure.
• Loop is 10" tall overall and has a 5" I.D.

• Stock replacement mount for securing oil filter to engine block when rebuilding or replacing an engine
• Oil Filter Adapter Small Block Chevy
• 1968-96 SB Chevy Including LT1 and 1968-90 Gen IV BB Chevy Engines
• Aluminum adapter with bypass valve bolts to block and has 13/16"-16 threads to accept oil filter

• Easily remove and install new valve cores.
• Base of handle has a machined pattern to aid with grip.
• Ergonomically designed and crafted from stainless steel.
• Measures 3" overall length.