Shopping

• Spool Cross Pin
• For GM 10-Bolt
• 7.5" Ring Gear

• Ensure that chassis tubing is level and plumb when building roll cages or checking driveshaft angles.
• Also works on trailing arms and suspension tubes when used with ALL10740 Smart Tool Tray.
• A "hold" button freezes and unfreezes readings which can be displayed as degrees, percentages, or in./ft. at the push of a button.
• Plus and minus signs indicate when pitch is more or less than that shown on the display. Pitch reads in 1/8 in./ft. increments.
• Listen and level emits an audible "beep" at level and plumb.
• The tool shuts off automatically if idle for more than six minutes.
• Powered by a standard 9 volt battery

• Plastic exhaust block off plate set
• 1/4" 1-piece design seal 23° standard SB Chevy exhaust ports
• Work great during engine storage or repairs
• Plates protect against moisture, dust and dirt
• Sold in Pairs

Not sure if you turned your wheels the same amount each time when adjusting caster settings on your race car? Unless you have expensive turn plates, you’re never certain, until now.

• Wheel Caster Setting Plate
• This quick reference gauge positions under the upper ball joint nut, with markings facing up, to easily view.
• Place a mark on the shock body or fabricate an indicator to use as a reference point.

• Tie downs are great for securing vehicles and pit equipment during transport.
• 2" x 8' long straps have heavy duty plated hardware,
• Ratchet designed to hold excess strap material as it is pulled through and wrapped up during tightening.
• The working load limit is the maximum load a strap should be subjected to during normal use.

• 40 foot roll of spring steel
• Use to make braces when hanging body and fender pieces
• Hardened and tempered coil is 40' long x 1" wide x .062" thick

• Sipers quickly and precisely sipe tires for better traction.
• Units have adjustable sipe depth.
• Lightweight tool uses standard utility blades and is constructed for heavy duty use.
• These tools should be handled with care.

• Tie downs are great for securing vehicles and pit equipment during transport.
• 2" x 8' long straps have heavy duty plated hardware
• Ratchet designed to hold excess strap material as it is pulled through and wrapped up during tightening.
• The working load limit is the maximum load a strap should be subjected to during normal use.

• 13/64" Drill Bits
• A common size bit for working with 3/16" flange type rivets
• High speed steel bits have black oxide finishes and self-centering tips
• Flute length: 1-3/16"
• Overall length: 2-1/4"
• Sold in Package of 2